Shape a Tight Metal Guitar Tone
For a tight metal rhythm, listen to two things separately: the bite when the pick hits and the silence between palm mutes. Start with a dry high-gain amp. Use Drive for the bite of the note. Once the attacks are distinct, listen to what the gate does to the quieter end of a ringing chord.
Apply the high-gain request, then play two low palm mutes and a ringing chord. Hear A and B.

Hear the input riff and the high-gain metal amp
Listen to the first low notes. A is the guitar recording as it enters our test. B repeats the same picking with a raspy, saturated edge. Turn the playback level to something comfortable once and leave it there for both.
A is the input file before BrowserTones processing. For B, the public player used its metal amp at 92% drive, a cabinet and no delay or reverb. Both clips use the same performance and are matched in loudness. To find your own setting, open the metal sound in the player and lower Drive until you can hear the gap between consecutive mutes.
What changes when a clean riff goes through a metal amp?
Listen to the end of each note. At 0:04 the same clean guitar part returns with heavy distortion. The note pattern stays the same while the notes sound thicker and sustain longer.
The request shown is Make it metal. High gain. No delay or reverb.
Try a high-gain rig in BrowserTones, then use the drive and gate checks below to keep your own riff clear.
Separate a loose attack from a boomy cabinet
Play a muted low string twice, then let an open power chord ring. If both muted notes smear together even at a low listening level, reduce drive first. Excess low end before distortion can cause the loud bass notes to crowd the rest of the chord. If the attack is already distinct but the ringing chord booms, try a small cut in low end after the amp or a different cabinet voicing. Compare the cabinet-only audio examples to hear that distinction.
Keep some midrange while testing with bass and drums. A tone that sounds immense by itself can lose the outline of the riff when the bass guitar occupies the same space. Lower tuning and heavier strings change the balance, so use the lowest notes from the actual song.
Set the gate using silence and sustain
Use three sounds in order: two stopped palm mutes, a quiet picked note, then a bar of silence with your hand on the strings. If the stops are tight but the quiet note vanishes, the gate is catching music. Ease it back until that note speaks. If the stops still run together with the gate eased back, return to Drive and listen to the space between the hits.
On a gate pedal, threshold sets the level at which it reacts. In BrowserTones, use the tone field and choose Apply prompt. We tried Dry high-gain metal rhythm with a tight noise gate, no delay or reverb.
Then we asked Keep the metal amp, turn off the noise gate and let the quiet picked notes ring out.
The player kept the amp and drive and switched the gate off in that session. Compare the end of a quiet note before deciding which setting to keep.
Use a favorite recording to identify one property: the dry stop, a sharp upper-mid attack or a thick sustained chord. Ask for that property specifically, then compare at the same volume. See the gain and EQ checks for a repeatable test phrase.
Try the high-gain metal rig in BrowserTones
By BrowserTones · Updated
