Fix No Guitar Sound in Your Browser

Start at the audio interface, not the amp settings. Pluck a string and check the input indicator, if your interface has one. No signal there? Check the guitar and cable. Signal there but silence in your headphones? Check the browser input and listening output next.

Check my input in BrowserTones

Choose Start playing, then compare Input Device and Output Device in Audio settings. Play the headphone check.

BrowserTones Audio settings with separate Input Device and Output Device selectors.
Check both selectors. The device receiving the guitar and the device playing the result can be different.

1. Does the guitar reach the interface?

Turn the headphone level down before changing connections. Plug the guitar into an instrument input, turn up the guitar’s volume and select INST or Hi-Z if your interface has that switch. Play one firm chord. Set enough input gain for the meter to respond without triggering its clip warning on your loudest stroke. Raising the headphone volume does not raise the input signal.

If the meter stays dark, try a cable you know works and check the physical channel. On interfaces without an input indicator, use the manufacturer’s input meter if available. If you are still wiring the rig, start with the guitar-to-computer connection diagram.

2. The meter moves. Is the browser listening to that input?

Open BrowserTones and choose Start playing. A browser permission labelled “microphone” also covers an interface’s audio input. Allow it for BrowserTones. Under Audio settings → Input Device, choose the interface rather than the laptop microphone. A device name identifies the interface; on a multichannel interface, also check which input your mixer sends to the browser.

If permission was previously denied, use Chrome’s site microphone settings to allow the site, check operating-system microphone permission, then reload and choose Start playing again. A running player tells you audio has started; it does not prove that a guitar signal is coming through.

3. Does sound reach the headphones?

Play the recorded chord below with the headphones in the same socket. Listen for where it actually comes out. This article plays through the browser’s normal media output. The amp can send its sound to another device.

Headphone check: one clean guitar phrase. No instrument input is needed.
  1. The clip is silent or comes from the speakers. Set the computer output to the interface, check its headphone volume and play the clip again.
  2. The clip reaches the headphones. From the player’s opening screen choose Try without a guitar. Check Audio settings → Output Device where output selection is available. If the clip works but the demo is silent, check the player’s output level and destination.
  3. The demo reaches the headphones. Choose Play with my guitar, allow input access and check Input Device. Pluck a string in the same headphones. If the demo worked but your guitar is silent, trace the cable, interface channel and input permission.

I hear a clean guitar, but changing the amp does nothing

You may be hearing the interface’s direct monitor: it sends the input straight to the headphones. Keep computer playback audible and turn down the direct-input side of the monitor mix. Apply a clearly different amp sound and play the same chord again. If removing the direct sound leaves silence, go back to the browser input and output checks. If the amp works but the note lands late, move to the guitar latency guide.

If you need help, report the first check that failed, interface model, input channel, browser and OS, and where the headphones are plugged in. “Input meter moves; computer audio works; no processed guitar” narrows the fault much more than “no sound.”

Check my input in BrowserTones

By BrowserTones · Updated